Homematic: Configuration data is pending transmission - you can do that
After a short period of work with the Homematic Central (CCU), the service message "Configuration data pending" can appear. We show in this manual what you can do with this message.
Homematic: Configuration data are pending transmission
The message "Configuration data is pending" appears when data has not been transferred to a particular smart home device. In this way, the control center cannot transfer the data to the end device in the event of changes and temporarily stores it. This then leads to the corresponding message.
With the following steps you get the error message away:
- First of all, check whether the data should be sent to a device with no regular reception. These are, for example, door and window contacts or push button interfaces.
- If one of these devices is affected, you must press the configuration button. This is usually a small hole on the housing of the respective device.
- For other components, press "transmit later", since most of them report in a regular rhythm and the data are then transmitted.
- The message can also appear when a control panel program is created. You can solve this problem by setting up the control center once as a receiver.
Shop recommendation for eQ-3 Homematic IP Radiator Thermostat HMIP-eTRV / 2 140280
€ 46.45
To the shop
€ 46.97
To the shop
€ 47.43
To the shop
Offered by BestCheck.de | Prices include VAT plus shipping
Compare other offers
Homematic: Further tips for configuration data error messages
- In the case of frequent reports, it is therefore advisable to set up a second control center program that reacts to everything but does not take any action.
- If the message is not wasted, it may be due to the amount of data. Press the configuration button until the status LED of the respective component goes out. Do this again if the message is still displayed.
- If the message also appears afterwards, the corresponding component is probably faulty and cannot establish a reception. In this case, delete the device from your control center and set up a replacement component instead of the defective one.
- However, configuration data is also transferred in the event of deletion. Simply bypass them and select "Remove only from control center" to also delete the pending configuration data
Shop recommendation for HomeMatic IP Starter Set smoke alarm device
€ 182.22
To the shop
€ 184.90
To the shop
€ 186.72
To the shop
Offered by BestCheck.de | Prices include VAT plus shipping
Compare other offers