Kobold VR200: Set up the vacuum robot
The Kobold VR200 from Vorwerk is finally there and unpacked - all you have to do now is set up the vacuum robot: filters, brushes and a full battery are missing before the first start-up, but then you can start.
Set up VR200: filters, brushes and battery charge
- First open the cover of the VR200 using the white button. Then pull on the green tab until the dust container can be removed.
- Then you have to put the filter in the opening of the dust container and put it back in the robot vacuum.
- Then turn your new robot vacuum upside down and carefully press the side brushes onto the drive axle from above.
- Insert the mains plug of the base station into the socket and place the robot vacuum cleaner in front of it. The VR200 starts to flash as soon as it is connected to the base station.
- The vacuum robot is not fully charged in its original state. Therefore, charge the batteries before using them for the first time. As soon as the LED operating display lights up permanently green, the robot vacuum is ready for operation. This can take about 1.5 hours. The full performance of the batteries is only achieved after approx. 2-3 full charging cycles, since the batteries still have to adapt to the device properties.
- By the way: You can find many other great tips on the Vorkwerk Kobold VR200 on our CHIP special page.
Buy Kobold VR200 robot vacuum online now